Hello everyone,I will introduce the Miku disposable vape.

Open the outer box, tear off candy wrappers.Remove the upper silicone plug.Tear off the bottom charging port dust-proof sticker.

Immediately suck.

Bluelight on the bottom when puffing, Miku's disposable vape are pre-filled with 8ml e-liquid.

Equivalent to the capacity of four 2ml pods. An average of 300 puffs per pods, So the 8ml is about 1200 puffs. But here is a note of 3000 mouths.

All are the names of the foreign trade market, Such as other disposable pods on the market, Note 3000, 5000. Actually none of that.

In addition, the battery capacity is 400mAh, output power 10 watts.

The new kit has a certain amount of power, When you feel less smoke during smoking, Indicates low battery. Can be charged using type-c interface.

The bottom indicator light is always blue when charging, It can be fully charged in about 45 minutes in a low power state, When fully charged, the bottom light will turn off.

Charge 3 to 4 times, you can basically use up 8 ml of e-liquid in it.

How to judge whether the disposable vape is out of e-juice?

When we feel the smoke is dry, the humidity of the smoke is reduced, not so full of smoke. You can try to open the cigarette holder and inject e-juice.

Taboo pumping until it smells sticky. Otherwise, there will be a sticky smell after refill. Next, the e-juice injection method will be shown. Press the top edge of the cigarette rod with your left thumb. With the right hand, move the cigarette holder upwards, Back and forth, until it open.

Above is condensed cotton, after taking out the condensed cotton. It is recommended to use a paper towel to dry the condensate in it, Below is a sealed silicone sleeve, pry open. Like this bulge stained with grease. Clean up with paper towels.

By looking at the color of this e-juice storage cotton, it's really dry and needs to be filled.

It is forbidden to inject e-juice into the middle intake hole. Instead, squeeze Miku e-liquid on the e-juice storage cotton around the air intake. 

No specific requirements for e-juice injection. According to the speed of the oil absorption rate of the e-juice storage cotton. Judging by color depth.

When the e-liquid is saturated, E-juice absorption becomes slower, The e-juice storage cotton will be darker in color.

After filling, then put back the sealing silicone sleeve, the sealing silicone ring is a little protruding.

Must be aligned with the fiber hole in the middle, press it a little to fix it. Here we can use a cotton swab. Break both ends of the cotton swab, put it in this hole. Then press the silicone ring down, with tweezers or something.

Press the silicone sleeve onto the contact surface of the cotton, pressed flat. If you don't do this.

Instead, press down the silicone ring directly. Easily pressed against the edge of the fiber tube.

Causes the air intake to be blocked and the smoke cannot be drawn. After the operation is done, the middle hole looks transparent. Then put the condensate on, close the cigarette holder and fasten it firmly.

Press to the perimeter of the rod and the edge of the mouthpiece without cracks. Stand for another 10 minutes, then it can be used normally.

Because it is a one-time kit. It is recommended to fill in e-juice once or twice, then replace the rod with a new one.